Building Brunhilde mtl

So finally I got the juice and atomizer I wanted.

Cutting short here, did build an mtl coil from 0.2*0.4 Ni80 ribbon wire, 2,5 ID about 5-6 twists, came out @ 1ohm, used vampire vape heisenberg 4 shots of 20mg 50/50 nicsalt, 10mg VG and 40mg PG, end result 30VG/70pg 8mg nic strenght, used the second biggest airflow, I think it was 2,1mm airflow pin, coil was placed fairly high, 2-3mm from ariflow, smoked at 17,5W on thelema solo, battery boost was on soft, wicking normal organic shoelace…

Read more

So finally I got the juice and atomizer I wanted.

Cutting short here, did build an mtl coil from 0.2*0.4 Ni80 ribbon wire, 2,5 ID about 5-6 twists, came out @ 1ohm, used vampire vape heisenberg 4 shots of 20mg 50/50 nicsalt, 10mg VG and 40mg PG, end result 30VG/70pg 8mg nic strenght, used the second biggest airflow, I think it was 2,1mm airflow pin, coil was placed fairly high, 2-3mm from ariflow, smoked at 17,5W on thelema solo, battery boost was on soft, wicking normal organic shoelace…

Read more 

Leave a Reply

Your email address will not be published. Required fields are marked *

× Whatsapp